Brocade Fabric OS Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 188)

This trap is generated by Fabric watch such that only the swUnitsStatusChange is controlled by the
switchStatusPolicySet command.
• connUnitSensorStatusChange
This trap is generated when there are changes in the sensor settings.
• connUnitPortStatusChange
This trap sends the instance of connUnitPortName as part of the trap; the instance string is NULL, if
the port name is not defined for the specified port.
• connUnitEventTrap
All the external traps gets converted into swEventTrap except for AN-1006, AUTH-3001 to
AUTH-3008, FW-3001, SEC-3001 to SEC-3034, and SEC-3044 to SEC-3048 RASlog messages.
Events in the Error Log of a severity at or above the configured threshold will generate SNMP traps.
The Fibre Alliance Trap (FA-TRAP) can be configured to send traps using the snmpConfig command.
For more information on this command, refer to the Fabric OS Command Reference.
HA traps
Consider enabling these traps to monitor field-replaceable unit (FRU) status and control processor
(CP) status when you have a Brocade director in your environment:
• fruStatusChanged
This trap is generated by a FRU status change, such as a switch reboot or disabling or enabling a
FRU component such as fandisable, fanenable and so on.
• cpStatusChanged
This trap is generated by a change in the status of a CP, including a reboot or firmware download.
• fruHistoryTrap
This trap is generated when a FRU is added or removed. It is not generated when standby CP is
removed.
The high availability trap (HA-TRAP) can be configured to send traps using the snmpConfig
command. For more information on this command, refer to the Fabric OS Command Reference.
SW traps
There are sixteen specific traps defined in Brocade SW-TRAP.
• swfault (no longer supported)
• swSensorScn (no longer supported)
• swFCPortScn - This trap is generated by a port state change.
• swEventTrap - This trap is generated by any switch event reported to the system error log. The
desired severity level is introduced to filter a swEvent trap based on the severity level.
• swFabricWatchTrap - This trap is generated when any Fabric Watch threshold is reached. The
desired severity level is introduced to filter a swFabricWatchTrap based on the severity level.
• swTrackChangesTrap (no longer supported)
• swIPv6ChangeTrap - This trap is generated when an IPv6 address status change event occurs. It is
generated only when IPv6 stateless state changes to the deprecation state and not for address
change notification.
• swPmgrEventTrap - This trap is generated when any partition manager change happens.
• swFabricReconfigTrap - The trap to be sent for tracking fabric reconfiguration.
• swFabricSegmentTrap - The trap to be sent for tracking segmentation.
HA traps
188 Fabric OS Administrators Guide
53-1003130-01