Brocade Fabric OS Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 44)

• Commands that take longer time to execute are not supported. The timeout period is 15 seconds.
• Returns only a maximum of 64 kilobytes of data from the remote switch. Any extra data gets
truncated.
• Not supported on FIPS and Access Gateway modes.
• When you run supportSave through fosexec, wait for the execution to complete. To know whether
the execution is completed, refer to the RASLOG [SS-1000] on all or the specific domain where
fosexec is being run.
• The fosexec feature must be disabled to downgrade from Fabric OS 7.3.0 to any other earlier
version.
NOTE
Running fosexec command does not log you out from the current session in your local switch.
Example 1
sw_85:root> fosexec --domain all -cmd "switchStatusPolicyShow"
Domain 1
=========
Enable remote fosexec feature.
Domain 74
=========
The current overall switch status policy parameters:
Down Marginal
----------------------------------
PowerSupplies 2 1
Temperatures 2 1
Fans 2 1
Flash 0 1
MarginalPorts 29.41%[12] 11.76%[5]
FaultyPorts 29.41%[12] 11.76%[5]
MissingSFPs 0.00%[0] 0.00%[0]
ErrorPorts 0.00%[0] 0.00%[0]
Number of ports: 40
Domain 85
=========
The current overall switch status policy parameters:
Down Marginal
----------------------------------
PowerSupplies 1 1
Temperatures 2 1
Fans 2 1
Flash 0 1
MarginalPorts 25.00%[6] 8.34%[2]
FaultyPorts 25.00%[6] 8.34%[2]
MissingSFPs 0.00%[0] 0.00%[0]
ErrorPorts 0.00%[0] 0.00%[0]
Number of ports: 24
Example 2
sw_85:user9> fosexec --domain all -cmd "islshow"
Domain 1
=========
Enable remote fosexec feature.
Domain 74
=========
RBAC permission denied.
Domain 85
=========
RBAC permission denied.
Example 3
sw_85:user9> fosexec --domain 74 -cmd "switchstatuspolicyshow"
Performing Basic Configuration Tasks
44 Fabric OS Administrators Guide
53-1003130-01