Brocade Mobility RFS7000 Controller Installation Guide - Manual (Page 10)

Warnings
1
2 Brocade Mobility RFS7000 Controller Installation Guide
53-1001574-03
Warnings
• Read all installation instructions and site survey reports, and verify correct
equipment installation before connecting the system to its power source.
• Remove jewelry and watches before installing this equipment.
• Install the equipment in a rack with adequate dimensions and weight
allowances.
• Verify the rack is anchored and cannot tip over or break away from its
mountings.
• Verify the unit is grounded before connecting it to the power source.
• Verify any device connected to this unit is properly wired and grounded.
• Connect all power cords to a properly wired and grounded electrical circuit.
• Verify the electrical circuits have appropriate overload protection.
• Attach only approved power cords to the device.
• Brocade strongly recommends the use of an Uninterruptible Power Supply
(UPS) that supports the IP-RFS7000 power rating. Not using a UPS can result in
data loss or equipment damage due to a power surge or power failure.
• Verify that the power connector and socket are accessible at all times during
the operation of the equipment.
• Do not work with power circuits in dimly lit spaces.
• Do not install this equipment or work with its power circuits during
thunderstorms or other weather conditions that could cause a power surge.
• Verify there is adequate ventilation around the device, and ambient
temperatures meet equipment operation specifications.
•
Before installing or handling the
Mobility RFS7000 Controller
, have on hand an
ESD wrist strap or other ESD voltage limiting device.
CAUTION
For safety reasons, the ESD wrist strap should contain a 1 meg ohm series
resistor.