American Audio SCD-100 - Manual (Page 16)

Activating the Pitch Slider (24):
To activate the PITCH SLIDER (24), you must turn the
pitch function on. Press the PITCH BUTTON (23) to turn
on the pitch function, when the pitch function is activated
the PITCH LED (10) will begin to glow. If the pitch function
is not activated the PITCH SLIDER (21) will not function.
11. PITCH ADJUSTMENTS
This function will increase or decrease the playback speed or "PITCH," of a track. The maximum pitch bend
percentage allowed is +/-12%. The PITCH SLIDER (24) is used to decrease or increase the playback pitch. If
the slider is move up (towards the top of the unit) the pitch will decrease, if the slider is moved down (towards
the bottom of the unit) the pitch will increase.
Using the Pitch Slider (24): To use the PITCH SLIDER
(24) slide the slider up and down. Down will increase the
pitch and up will decrease the pitch. When the slider is in the
center position, there is zero pitch being applied to a track.
Figure 13
Figure 12
Figure 14
BASIC OPERATION
© American Audio ® - www.americandj.com - SCD-100™ Instruction Manual Page 16
TRACK M S F
COMPACT
DIGITAL AUDIO
1 BIT 8 TIMES OVERSAMPLING D/A CONVER TER COMP ACT DISC PLA YER
ON
OFF
TRACK M S F
COMPACT
DIGITAL AUDIO
1 BIT 8 TIMES OVERSAMPLING D/A CONVER TER COMP ACT DISC PLA YER
ON
OFF
10. CHANGING THE TIME DISPLAY (30, 31, & 32)/TIME BAR (33):
The time may be displayed in three different modes; Elapsed and Remain. During normal playback, pressing
the TIME BUTTON (3) as in figure 11, will change the time display information (30, 31, 32, & 33) in the LCD.
The following is a break down of the time settings and their definitions:
1) ELAPSED (34) - This details the time in the LCD (30, 31, & 32) as the current tracks’ elapsed running time.
The elapsed function only details a tracks elapsed time and not the entire disc.
2) REMAIN (37) - This details the time in the LCD (30, 31, & 32) as the current tracks’ remaining running time.
TIME BAR INDICATOR - The time bar in the LCD visually details the time defined in the TIME METER (30, 31,
TIME METER ( TIME METER (
& 32). This bar is also dependent on the selected time function; REMAIN (37) or ELAPSE (34). This bar will
begin to flash when 15 seconds of a track remain and will begin to rapidly flash when three seconds
of a track remain. The flashing bar is a great visual reminder a track is about to end. The flashing bar
will function regardless of which time mode the unit is in.
TRACK M S F
COMPACT
DIGITAL AUDIO
1 BIT 8 TIMES OVERSAMPLING D/A CONVER TER COMP ACT DISC PLA YER
ON
OFF
Figure 11