Burcam 700506 CENTRIFUGAL PUMP 1.5HP 230V - Manual (Page 2)

FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029
2
SAFETY INSTRUCTIONS:
This fine pump that you have just purchased is designed from the latest in material and
workmanship.
Before installation and operation, we recommend the following procedures:
CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO
ENSURE YOU COMPLY WITH THE REGULATIONS. THESE CODES HAVE
BEEN DESIGNED WITH YOUR SAFETY IN MIND. BE SURE YOU COMPLY
WITH THEM.
WE RECOMMEND THAT A SEPARATE CIRCUIT BE LEAD FROM THE HOME
ELECTRICAL DISTRIBUTION PANEL PROPERLY PROTECTED WITH A
FUSE OR A CIRCUIT BREAKER. WE ALSO RECOMMEND THAT A GROUND
FAULT CIRCUIT BE USED. CONSULT A LICENSED ELECTRICIAN FOR ALL
WIRING.
THE GROUND TERMINAL ON THE THREE PRONG PLUGS SHOULD NEVER
BE REMOVED. THEY ARE SUPPLIED AND DESIGNED FOR YOUR PRO-
TECTION.
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR
PRODUCT WITH THE POWER CONNECTED. DO NOT ONLY UNSCREW
THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER PLUG FROM
THE RECEPTACLE.
A
B
C
D
Material required for drilled well application
Pump installation
Suction line
❏ Desired length of polyethylene 2” pipe CSA or
UL approved, to link up from pumping level to pump.
❏ 1 2” foot valve (750759).
❏ 2 2” male adaptors.
❏ 4 2” stainless steel clamps.
❏ Teflon tape.
Pump installation
Discharge line
❏ Desired length of polyethylene 1 1/2” pipe, 100PSI, CSA
or UL approved.
❏ 1 1/2” male adaptors.
❏ Teflon tape.
❏ Desired quantity of sprinkler for irrigation.
Tools
Screwdrivers, hacksaw to cut pipe, knife to assist in pipe cutting, round file to smooth pipe ends, pipe wrench,
adjustable wrench to tighten fittings, propane torch and welding material.