Burcam 300208 UTILITY PUMP 1/2HP 115V - Manual (Page 3)

FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029
IMPORTANT INFORMATIONS
R The automatic thermal overload protection shuts the motor off when it overheats because of low voltage,
trash in the pump or other problems. Normally, motor cools in 10 minutes and restarts automatically.
R If this pump is used for pumping mildly abrasive liquids like lake water, keep hose inlet above mud and
sand. All severely abrasive liquids will wear the pump quickly and void warranty.
R This pump will handle water only at temperatures of 0°F to 120°F (-18°C to 50°C).
Thick liquids, fuels (gasoline etc) or other flammable liquids, solvents,
thinners and strong acids are totally prohibited.
R Never operate the pump against a closed or clogged discharge.
R Use 1/2” (13mm) minimum pipe. Note that the best performance occurs when the suction line is as short
and direct as possible. For any lines of 40’ or longer, install a 3/4” (19mm) pipe size.
R After few months of inactivity, the impeller may get dry. If this happens, replace the impeller.
R The motor is drip-proof but not waterproof.
R Motor brushes should be replaced every 150 hours of use. Remove brush cap to replace brush only.
R Never add oil to motor or brushes.
PRIMING
This unit will prime to 10 feet if you follow these instructions. Drop 1 tablespoon of vegetable oil into pump
inlet and outlet before each use. Add water to suction pipe and install a foot valve to make easier priming.
For a succion from 10’ to 20’ depth, a foot valve is mandatory and the suction line must be filled before pump
start. If the pump does not prime within one (1) minute, unplug from receptacle and perform next steps:
R Air leaks in suction pipe. For a garden hose, be sure fittings are tight and rubber washers are in good
condition. For other pipe types, use teflon tape on all threads.
R Verify foot valve action
3