Burcam 300608 CAST IRON SUBM. SUMP PUMP MECHANICAL SWITCH 1/3HP 115V - Manual (Page 2)

SAFETY INSTRUCTIONS:
This fine pump that you have just purchased is designed from the latest in material and
workmanship.
Before installation and operation, we recommend the following procedures:
CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO
ENSURE YOU COMPLY WITH THE REGULATIONS. THESE CODES HAVE
BEEN DESIGNED WITH YOUR SAFETY IN MIND. BE SURE YOU COMPLY
WITH THEM.
WE RECOMMEND THAT A SEPARATE CIRCUIT BE LEAD FROM THE HOME
ELECTRICAL DISTRIBUTION PANEL PROPERLY PROTECTED WITH A
FUSE OR A CIRCUIT BREAKER. WE ALSO RECOMMEND THAT A GROUND
FAULT CIRCUIT BE USED. CONSULT A LICENSED ELECTRICIAN FOR ALL
WIRING.
THE GROUND TERMINAL ON THE THREE PRONG PLUGS SHOULD NEVER
BE REMOVED. THEY ARE SUPPLIED AND DESIGNED FOR YOUR
PROTECTION.
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR
PRODUCT WITH THE POWER CONNECTED. DO NOT ONLY UNSCREW
THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER PLUG FROM
THE RECEPTACLE.
A
B
C
D
Material required for submersible sump pump application
Submersible sump pump installation
 Desired length of 1 1/2” or 1 1/4” of ABS/DWV pipe to link up the pump to the drain line.
 1 only 1 1/4” check valve (350353) (Note that this 1 1/4” check valve may also be use with
a 1 1/2” pipe).
 Sump pit or 1 only sump basin.
 1 1/4”-1 1/2” stainless steel clamps (750886).
 ABS cement.
2
Tools
Screwdrivers, hacksaw to cut pipe, knife to assist in pipe cutting, round file to smooth pipe
ends, pipe wrench, adjustable wrench to tighten fittings.
NOTICE
This unit is not designed for applications
to pump salt water or brine .
Use with salt water or brine will void
warranty.