Condec DLR334 User Manual

Page 4

Advertising
background image

PAGE 4

74845

♦

General commands (Zero, etc.).

♦

Display commands (Min,Max, etc.).

♦

Pressure calibration (Zero Cal, etc.).

Data request code = < R > character (3FH).

‘R’ commands requesting data from the host to the DLR.
♦

Pressure data.

♦

Status.

♦

Setup data.

Calibration data.

Data entry code = < E > character (45H).

‘E’ commands with data sent from host to be entered into the DLR.
♦

Setup data.

♦

Calibration data.

For complete listing of command codes see Table II.

4.0

DATA FORMAT:

4.1 GENERAL:

! When data is transmitted it is always bracketed with the ‘{‘ and ‘}’ characters.

! The separation character ‘|’ (7CH) is used to separate data in a string.

! All DLR recalled data has leading zero suppression with the zeros transmitted as spaces.

! All data entered into the DLR can have leading zero suppression with the zeros transmitted

as spaces but is not required.

! Summary of data formats:

PRESSURE:

<value><units><par><stat>

STATUS:

WEIGHT: <stat>
INPUT:

<I1>|<I2>

OUTPUT: <O1>|<O2>

SETUP: <par 1>|<par 2>| - - - <par x>

5.0

RESPONSE:

! In the print/port 1/duplex setup the response by the DLR from the direct commands and data entry

commands can be selected for ‘None’ or Echo’.

‘None’: no response is given a direct cmd (D) or data entry cmd (E) if valid or invalid.

‘Echo’: the command (direct or entry) is echoed as received if valid; the start of transmission
character is returned with a ‘:’ not the ‘*’ character. If invalid a _NAK_ is returned

‘Ack/Nak’: instead of echoing back the received command code and entered data the DLR
responds with ‘ACK’ (41H, 43H & 48H) in place of the code. If an error in received data is
detected the DLR responds with ‘NAK’(4EH, 41H & 48H).

Ack response: :ACK<CR>
Nak response: :NAK<CR>

! An invalid input consists of the following:

♦

Parity error.

♦

Check error if enabled.

♦

Invalid command code.

♦

Invalid data format.

Response in Echo or Ack/Nak mode = :NAK<CR>

Advertising