Davey Aquashield MAX Packaged Ultra Violet Water Treatment System - Manual (Page 5)

5
Prior to using this system you must ensure that:
• The system is installed in a safe and dry environment
• The system enclosure has adequate drainage in the event of leakage
• Any transport plugs are removed
• The pipe-work is correctly sealed and supported
• The pump is primed correctly
• The power supply is correctly connected
• All steps have been taken for safe operation
CHOOSING A SITE
Choose a site with a firm mounting position. Allow room for removal of the
lamp and sleeve during servicing. leave a chamber lengths space above
the lamp cover & connector end for lamp removal.
To protect your system from the weather, make sure the site is flood proof,
water proof, frost free and has adequate ventilation. allow for drainage, to
avoid damage due to flooding etc., that over time may occur from leaking
pipe joints or seals.
POWER CONNECTION
Connect lead to power supply designated on control box label. Check that
the earth is connected to the stainless steel chambers using bolt provided
on the chamber.
WARNING: Some insects, such as small ants, find electrical devices
attractive for various reasons. If your site or enclosure is susceptible to
insect infestation you should implement a suitable pest control plan.
WARNING: When servicing or attending your Aquashield MAX, always ensure
power is switched off and lead unplugged. Electrical connections should be
serviced only by qualified persons. If the electrical supply lead of this system
is damaged, it must only be replaced by a qualified service personnel.
The Steriflo ® control box has a red LED alarm indicator light mounted on
its front panel, adjacent to the amber “power on” LED. This light will be
illuminated whenever the Steriflo
® control box senses no lamp current. There
is also an audible alarm in the event of lamp failure. The LED and/or alarm
will only work when unit is connected to the correct electrical supply.
NOTE:
a) For protection, the Davey
® pump motor is fitted with an automatic
“over temperature” cut-out. Constant tripping of this overload device
indicates a problem e.g. low voltage at pump, excessive ambient
temperature (above 50°C) in pump enclosure.
b) The Torrium ® control device may have to be reset after rectifying any of
the above operating troubles. This is done by pushing in the “prime”
button and releasing it after 2 seconds, or switching the power supply
off then on.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.