Elitegroup A535 User Manual
Page 104
102
Remove the screws that secure the RAM module compartment cover and set
it aside in a safe place.
3
3
.
.
4
4
.
.
5
5
.
.
6
6
.
.
7
7
.
.
8
8
.
.
9
9
.
.
1
1
0
0
.
.
Remove the compartment cover and then angling it up and out.
If you need to install a higher capacity module, gently push the edge clips on
both sides to release the module. Angle the card slightly upward and gently
slide it from its edge connector slot. Store the card in the anti-static bag that
contains your new module(s).
To install the new memory card, hold the card with its gold edge connector
toward the edge connector slot of the compartment. To help you orient the
cards, the edge connector has been made with two unequal-length sections.
You will only be able to insert the card in one direction.
Insert the edge connector into the slot. The gold edge connector of the card
should not be visible when the card is fully inserted.
Press the card downward where you should hear an audible click as the
latches of the connector secure the card in place.
Once the module is properly seated, you can replace the cover on this
compartment.
Replace and tighten the screw.