Elitegroup P71EN installation - Manual (Page 32)

VT6420 User Manual – SATA Controller
Revision 1.01, May 19, 2003 28 RAID Software
Add and Remove Spare Disk Drive
Add Spare Disk Drive
A spare disk drive can be added when a RAID 1 array is created. The capacity of the spare disk drive must be greater than or
equal to the capacity of the RAID 1 array. If there is no spare disk drive in a RAID 1 array, user can add a spare disk drive after
RAID 1 array is created by clicking on .
1. Select the RAID 1 array in the left windowpane and click on , the available disk drives will then be listed in a popup
window.
2. Select a disk drive and click on OK to add a spare disk drive to RAID 1.
3. A warning message will popup, click Yes to finish adding the spare disk or No to cancel it.