FallTech Contractor Series SRL’s User Manual

Page 11

Advertising
background image

21

requirements for training. FallTech has additional services available to
assist with end-user training – contact a FallTech sales professional for
additional details.

As a minimum, training should address the following points:

 ABCD’s of Fall Arrest (as discussed in Section 2).

 Recognition of fall hazards.

 Fall hazard elimination and control methods.

 Applicable fall protection regulations and standards.

 The responsibilities of designated persons (Authorized,

Competent, Qualified).

 How to use written fall protection procedures.

 Inspection of equipment components and systems before use.

 Fall protection rescue procedures.

 Installation and use of products common to your duties, job-site

or facility.


It is important to note that improper use of this equipment can be just
as dangerous as not using it at all. Failure to read, understand and
follow these instructions may result in serious injury or death.

Section 7: Fall Protection Plan


Title 29 CFR, section 1926.500 – 503 requires that an employer have
a written fall protection plan where fall hazards exist. The best way to
address a fall hazard is to eliminate it entirely or to employ a passive
system to restrict access to the hazard (i.e. guardrails, netting, covers,
etc.) Fall arrest products are the last line of defense in the hierarchy of
fall protection, and should be used as a last resort by employees who
have been thoroughly trained. The accepted fall protection hierarchy is
as follows:

 Eliminate the fall hazard.

 Passive fall protection (guardrails, safety nets, barriers, etc.).

 Fall Restraint (prevent the worker from having access to the fall

hazard by using a fixed lanyard which is short enough to restrict
access to the hazard).

 Fall Arrest (utilizing Personal Fall Arrest Systems).

 Administrative Controls (use of warning lines, controlled access

zones or monitors).


Two exceptional resources for developing a written fall protection
plan are OSHA 1926 Subpart M, Appendix E and ANSI Z359.2-2007. All

22

ANSI standards are available for purchase at www.ansi.org in the e-
standards store.


7.1: The Fall Protection Plan

As a minimum, a fall protection plan should identify and/or address
the following points:

 Any and all fall hazards which may exist on your job-site

or in your facility.

 Steps that have been taken to eliminate each fall hazard.

 Equipment that has been or will be employed to address

each fall hazard.

 Provisions for 100% continuous fall protection in the

vicinity of all fall hazards.

 Training procedures for all authorized persons.

 Identification

of

acceptable anchorages for positioning,

restraint and fall arrest.

 Clear-fall

requirements.

 Use and egress from the system.

 Limitations on use of the system (maximum Free-fall,

arrest force and maximum number and permitted
locations of authorized persons who may use the system).

 Procedures for installation, use and removal of the

system.

 Detailed instructions for inspection of systems and system

components to include rejection criteria and replacement
procedures.

 A detailed plan and procedures for the rescue of a worker

who may be involved in a fall event.


7.2: Rescue Plan

In the event of a fall, OSHA requires that a prompt rescue be
provided. In order to facilitate a prompt and effective rescue, it is
important to have a Rescue Plan as part of your overall Fall Protection
Plan.

The rescue plan should include detailed procedures for summoning a
professional rescue agency (such as the local fire department) and/or for
performing self-rescue or in-house rescue.

For detailed assistance in formulating and maintaining an effective
rescue plan, see ANSI Z359.2-2007.

Advertising
This manual is related to the following products: