General hazard warning, Warning, Use of equipment – Hired-Hand Super-Savers (Forced Air Heaters) XL: HH-SS-175-XL User Manual

Page 2: Electrical

Advertising
background image

Part No. 4801-1016 Rev 6-09

Super-Saver XL Heater – 100 Volt

Page

2 of 21

GENERAL HAZARD WARNING

Failure to comply with precautions and instructions provided with this heater can result

in death, serious bodily injury and property loss or damage from hazards of fire,

explosion, burn, asphyxiation, carbon monoxide poisoning, and/or electrical shock. If

you need assistance or heater information such as an instruction manual, labels, etc.

contact the manufacturer.

WARNING

Keep solid combustibles, such as building materials, paper, cardboard, feathers, straw

and dust a safe distance away from the heater as recommended by the instructions.

Never use the heater in spaces which contain or may contain volatile or airborne

combustibles, or products such as gasoline, solvents, paint thinner, dust particles, or

unknown chemicals. Failure to follow these instructions may result in a fire or

explosion, property damage, personal injury or loss of life.

WARNING

Not for home or recreational vehicle use. Installation of this heater in a home or

recreational vehicle may result in a fire or explosion, property damage, personal injury

or loss of life.

WARNING

Proper gas supply pressure must be provided to the inlet of the appliance. Refer to

rating plate for proper gas supply pressure. Gas pressure in excess of the maximum

inlet pressure specified at the appliance inlet can cause fires or explosions, leading to

serious injury, death, building damage or loss of livestock.

Likewise, gas pressure below the minimum inlet pressure specified at the appliance

inlet may cause improper combustion, leading to asphyxiation, carbon monoxide

poisoning and therefore serious injury or death to humans and livestock.

USE OF EQUIPMENT

The intended use of this appliance is the heating of agricultural animal confinement

buildings

.

ELECTRICAL

The electrical connections and grounding of the appliance shall be in compliance with

the National Electrical Code ANSI/NFPA 70.

!

!

!

!

Advertising