Hired-Hand Farm Hand Series: Data Shuttle Launch Pad - Manual (Page 20)

Part No. 4801-0165 Rev 7-02 Data Shuttle Launch Pad 18
Select MENU: or TOOL BAR:
prevents the cycle alarm from sounding.
Low Pressure Alarm - The Low Pressure alarm will send a signal when pressure drops
below the Low Pressure setpoint for greater than 45 seconds. This alarm warns if the
vents failed to close.
Disable Low Pressure Alarm – Checking this box prevents the Low Pressure alarm
from sounding.
High Pressure Alarm - The High Pressure alarm will send a signal to your existing
alarm system in the same manner as the Low Pressure alarm, but only when pressure
exceeds the High Pressure Setpoint for greater than 45 seconds. (High Negative
Pressure.) This alarm warns if the vents did not open.
Disable High Pressure Alarm – Checking this box prevents the High Pressure alarm
from sounding.
14. Reading from the Data Shuttle
Connect the Data Shuttle to the selected communications port of the computer. Verify that the
Data Shuttle has been previously “launched” and is functioning properly by noting the LED is
flashing every two seconds.
Starting
Click on the Shuttle tool bar or the menu bar. From
the drop-down menu click Read from Shuttle or
press the F6 function key. The Read Data Shuttle
screen provides three options when reading from
the Shuttle:
(1) Read Temperatures and Continue Logging– Reads the Data Shuttle and continues
temperature recording as already
programmed. With this option
there is no additional programming
or push button operations required
by the Shuttle. After the Launch
Pad reads the Shuttle data, the Save
As window will appear. See the
next section for discussion of the
Save As Window.
(2) Read Temperatures and Reset Data Shuttle– Reads the Shuttle data and clears the
Shuttle memory so the Shuttle can be re-
programmed. After the Launch Pad reads the
Shuttle data, the Save As window will appear. See
the next section for discussion of the Save As
Window. If the Shuttle has not been triggered, a
warning message will appear and Launch Pad will
not attempt to read from the Shuttle.