Hired-Hand Contactor Control System (CCS): 4, 8, or 12 Stage - Manual (Page 12)

Contactor Control Systems 10
OUT IN
L1 L2 L1 L2 L1 L1 L1
OUT IN
L2 L1 L2
OUT IN
L2 L1 L2
OUT IN
L2 L1 L2
Stage 1 5 9 Stage 2 6 10 Stage 3 7 11 Stage 4 8 12
OUT IN
L1 L2 L1 L2 L1 L1 L1
OUT IN
L2 L1 L2
OUT IN
L2 L1 L2
OUT IN
L2 L1 L2
Stage 1 5 9 Stage 2 6 10 Stage 3 7 11 Stage 4 8 12
LIGHTS
COMMON
120VAC HOT
120VAC NEUT.
GROUND
FAN
CONTROL MICRO SWITCH
All wiring must meet N.E.C. and all Local Standards.
120/240 VAC Hot
120/240 VAC Neutral
Ground
240 VAC Line 1 240 VAC Line 2 240 VAC Line 1 240 VAC Line 2
Breaker Panel
CCS Panel
Stage Load
Note: When using a single pole contactor,
only line 2 of the 120 Volt supply to the stage
is broken by the contactor.
Connecting Power from Breaker to a Heat Stage
Using the CCS Panel
120V/240V
Heater
120V/240V
Ground
Ground