Hired-Hand Contactor Control System (CCS): 4, 8, or 12 Stage - Manual (Page 4)

Contactor Control Systems 2
4. Limited Warranty
All products are warranted to be free from defects in material and workmanship for a period of one
year from the date of purchase if installed and used in strict accordance with the installation
instructions. Liability is limited to the sale price of any products proved to be defective or, at
manufacturers option, to the replacement of such products upon their return. No products are to be
returned to the manufacturer, until there is an inspection and/or a return-goods authorization
(RGA) number is issued.
All complaints should be directed first to the authorized distributor who sold the product. If
satisfaction is not obtained or the name of the distributor is not known, write the manufacturer that
appears below, directed to the attention of Customer Service Manager.
This limited warranty is expressly in lieu of any and all representations and warranties expressed or
implied, including any implied warranty of merchantability or fitness for a particular purpose. The
remedy set forth in this limited warranty shall be the exclusive remedy available to any person. No
person has authority to bind the manufacturer to any representation or warranty other than this
limited warranty. The manufacturer shall not be liable for any consequential damages resulting
from the use of our products or caused by any defect, failure or malfunction of our products.
(Some areas do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you.)
This warranty gives you specific legal rights and you may also have other rights that vary from
area to area.
Warrantor:
Hired-Hand, Inc.
1733 Co. Rd. 68
PO Box 99
Bremen, AL 35033
5. Installation
5.1. Tools Required
Drill Screwdriver
Crimping Pliers Kit Bag (Included)
5.2. Instructions
1. Unpack system, and check that all components are present.
2. Insert two screws into wall approximately 18” apart, leaving the heads away from the
wall.
3. Hang CCS PANEL over the two screws. The top two holes in the side flanges are
slotted to allow easy hanging.
4. Finish mounting the unit by securing the sides with eight more screws
5. Make sure all power supplies are disconnected before breaking any wires, or
reaching into the panel.
6. Open CCS panel, and find all connections.
7. Run sensor out to location inside the house.
8. Connect the sensor to its appropriate terminals inside the CCS panel. (See wiring
diagrams in the back of this manual.)