Hired-Hand Farm Hand Series: Vent Master 24 - Manual (Page 14)

Part No. 4801-5124 rev 10-03 Farm Hand Vent Master 24 12
9.8 Sensor Calibration
The Vent Master 24 has four sensors that may be calibrated. The parameter(s) for calibration
are PSx with x being the sensor number. The sensor temperature reading is alternately
displayed along with the parameter number. You should never attempt to calibrate a sensor
more than 8 degrees. If you have a setting that far out of range, it indicates that there is a
problem that should be corrected.
PS1 -- Calibrate Sensor 1
This reading can be changed by pressing the + or - button until the desired
reading is displayed.
PS2 -- Calibrate Sensor 2
This reading can be changed by pressing the + or - button until the desired
reading is displayed.
PS3 -- Calibrate Sensor 3
This reading can be changed by pressing the + or - button until the desired
reading is displayed.
PS4 -- Calibrate Sensor 4
This reading can be changed by pressing the + or - button until the desired
reading is displayed.