Lincoln Electric IM713 POWER WAVE 655R - Manual (Page 24)

C-1 ACCESSORIES C-1
OPTIONAL EQUIPMENT
FACTORY INSTALLED
There are no factory installed options available for the
Power Wave
® .
FIELD INSTALLED
Gas Guard Regulator (K659-1)
The Gas Guard regulator is available as an optional
accessory for Power Feed
® Robotic wire drive unit.
Install the 5/8-18 male outlet on the regulator to the
proper 5/8-18 female gas inlet on the back panel of
the wire drive. Secure fitting with flow adjuster key at
top.
Voltage Sense Leads (K490-10, -25 or -50)
The voltage sense leads connect at the front of the
machine. (See “Voltage Sensing” in the Installation
Section for use and Wiring Diagram Section Codes
11410, 11880).
Cool Arc 40 (K1813-1)
(See Wiring Diagram Section Codes 11410, 11880)
POWER WAVE ® 655/R
* Water Flow Sensor (K1536-1)
Water cooled guns can be damaged very quickly if
they are used even momentarily without water flow-
ing. Recommend practice is to install a water flow
sensor such as on the water return line of the torch.
When fully integrated into the welding system, the
sensor will prevent welding if no water flow is pre-
sent.
• Dual Cylinder Undercarriage, K1570-1*
*The Dual Cylinder Undercarriage, K1570-1 is not
compatible in combination with the Power Wave ®
Water Cooler K1767-1.
• Coaxial welding Cable, K1796
(See Pin, Lead Connector Diagram Section)