Lincoln Electric IM564 SP-100T - Manual (Page 9)

A-2 INSTALLATION
SP-100T
A-2
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the SP-100T
from its carton and remove all packing material
around the SP-100T. Remove the following loose
items from the carton (see Figure A.1):
1. SP-100T
2. Gun and cable assembly (1)
3. Literature and miscellaneous including:
a) This operating manual
b) 6 extra .023"-.025” (0.6 mm) contact tips
c) Hex key wrench for removal of drive roll.
4. 10 ft (3.0 m) work cable.
5. Work clamp.
6. Sample spool of .025” (0.6 mm) L-56 MIG wire.
7. Handshield with filter plate and lens.
8. Instructional video.
9. Adjustable mixed-Gas Regulator & Hose.
For available options and accessories refer to the
Accessories Section of this manual.
1) As shipped from the factory, the SP-100T gun liner
is ready to feed .023” (0.6 mm) -.035 (0.9 mm) wire.
The contact tip is sized for .023”-.025” (0.6 mm) wire
feeding.
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the SP-100T Operating Manual
should install and operate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The SP-100T power switch is to be in the
OFF (“O”) position when installing work
cable and gun and when connecting power
cord to input power.
WARNING
FIGURE A.1
SP-100T SP-10
0T
1
2
3
4
6
7
8
9
5