Lincoln Electric IM710 SP-170T - Manual (Page 15)

A-6 INSTALLATION
ELECTRICAL INPUT CONNECTION
FOR RATED OUTPUT
ELECTRIC SHOCK can kill.
• Disconnect input power by
removing plug from receptacle
before working inside SP-170T.
• Use only grounded receptacle.
• Do not touch electrically “hot”
parts inside SP-170T.
• Have qualified personnel do the
maintenance and troubleshooting
work.
Line Cord Connection
A three conductor line cord with a 15 amp, 240 volt,
three pin plug is factory installed. Connect this plug to
a mating grounded receptacle which is connected to
an appropriate power supply per the Wiring Rules and
any applicable local codes.
This welding machine must be connected to a
power source in accordance with applicable elec-
trical codes.
If there is any question about the installation
meeting applicable electrical code requirements,
consult a qualified electrician.
WARNING
WARNING
A-6
SP-170T