LT Security LTD2316ME - Manual (Page 30)

DVR User Manual
24
Fig 4-11 record configuration-enable
Step2: tick off record, audio and record time
Step3: select All to setup all channels with same parameters.
4.3.2 Record stream
Step1: enter into system configurationrecord configurationrecord bit rate; refer to Fig 4-12:
Step2: setup rate, resolution, quality, encode and max bit stream
Step3: user can setup all channels with same parameters, tick off
“All”, then to do relevant setup.
Step4: click “default” button to resort default setting; click “apply” button to save the setting; click “exit” button to exit current
interface.
Note: if the rate value set is over high the maximum resources of the device, the value will be adjusted automatically.
Fig 4-12 record configuration-record bit rate
Parameter Meaning
Rate Range from: 1-30
（NTSC）1-25(PAL)
Resolution Support CIF, HD1 and D1
Quality The higher the value is, the clearer the recorded
image is. Six options: lowest, lower, low,
medium, higher and highest.
Encode VBR and CBR
Max bit
stream
Range from: 64 Kbps, 128 Kbps, 256 Kbps,
512 Kbps, 768 Kbps, 1Mbps, 2 Mbps