LT Security PTZ217X12 User Manual - Manual (Page 14)

User Manual of 4-inch High Speed Dome
5
Chapter 2 Getting Started
2.1 Power-up Action
After the power is applied, the speed dome will perform a series of self-test actions. It performs lens
actions firstly, then the panning movement and the tilting movement at last. After the power-up
self-test actions, the system information will be displayed for 2 minutes on the live view screen as
shown below.
TYPE DS- 2XX1-XXX
SN 000000000
ADDRESS 0
COM FORMAT 2400,8,1
PROTOCOL ADAPTIVE
VERSION 0. 00
HARDVERSI 0. 00
BUILD DATE 12 05 17
Figure 2-1 System Information
Table 2-1 Descriptions of the System Information
System Info Description
TYPE The model of the speed dome.
SN The serial number of the speed dome.
ADDRESS The default communication address of the speed dome.
COM Format
The communication settings of the speed dome. Baudrate (4 digits),
data bit (1 digit) and stop bit (1 digit).
PROTOCOL It is for communicating with other devices.
VERSION The version of the firmware.
HARDVERSI The version of the hardware.
BUILD DATE The date when the program of the software is compiled.
Note: You have to configure a protocol, an address and a baudrate for the dome the same as it in
the other devices.
2.2 Basic Operations
You can operate the speed dome using a control device. The control devices include the control