LT Security PTZ217X12 User Manual - Manual (Page 37)

User Manual of 4-inch High Speed Dome
28
TIME TASK
TASK NUM 1
TASK STATE ON
TASK ACTION NONE
TASK TIME
TASK PREVIEW
TASK CLEAR
BACK EXIT
Figure 3-20 Time Task Configuration Menu
3. Set the task status.
Steps:
(1) Move the cursor to TASK STATE and click IRIS+ to enter edit mode.
(2) Click the up and down direction buttons to set the task status to ON.
(3) Click IRIS+ again to confirm and exit edit mode of this column.
4. Configure the task action.
Steps:
(1) Move the cursor to TASK ACTION and click the IRIS+ to enter edit mode.
(2) Click the up and down direction buttons to select the task action from preset 1 to 8, pattern
1 to 4, patrol 1 to 8, panning scan, tilting scan, random scan, frame scan, panoramic scan,
day mode, night mode and none.
(3) Click IRIS+ again to confirm and exit edit mode of this column.
5. Set the task time.
Steps:
(1) Move the cursor to TASK TIME and click IRIS+ to enter edit mode.
(2) Click the left and right direction buttons to position the cursor to WEEK, START (H-M) and
END (H-M).
(3) Click the up and down direction buttons to select the specific day and time.
(4) Click IRIS+ to confirm and exit.
Note: The weekday can be set to be from Monday to Sunday or Whole Week.
WEEK WHOLE WEEK
START(H-M) 00 00
END(H-M) 00 00
DONE: OPEN
QUIT: CLOSE
Figure 3-21 Set the Task Time