LumaSense Technologies M390S - Manual (Page 10)

M390S Manual Introduction 10
2.2 Technical Data
This Model Model Temperature Range
[ ] M390-S 600 to 3000 °C (1110 to 5430 °F) Custom split design
Accuracy: ±0.25% of reading ±1 C
Cavity: Closed end graphite tube 150 mm (6.0") long with 64 mm (2.50")
heated length
Source Diameter: 25 mm (1.00")
Emissivity: 0.995 ± 0.003
Cooling: Water cooled. Standard hose connection on rear, 3 lpm (1 gpm)
Cooling Inlet Pressure: 90 PSI maximum
Customer is responsible to provide pressure safety valves at inlet
and outlet. Outlet (drain) must not be blocked.
Purge Gas: Argon High Purity (99.99% pure)
Purge Gas Inlet Pressure: 25 PSI maximum. Customer is responsible to provide over
pressure safety valves at inlet
Heating Element Type: Graphite tube argon gas purge, 80 lph (4-8 cfh)
Temperature Sensor: Mikron "Infraducer"
Method of Control: Digital PID Controller
Remote Set Point: RS422 serial communication output
Warm-up Time: 5 minutes from ambient to 2300 °C
Operating Ambient Temp.: 0 C to 44 C (32 F to 110 F)
Operating Ambient
Humidity:
0 to 90% RH non-condensing
Power Requirements: [ ] 208 or [ ] 220 or [ ] 240 VAC ±10% [ ]50 [ ]60Hz
[ ] 15 kVA [ ] 24 kVA (specified at time of order)
Power Connector: Customer supplied.
[ ] 15kVA
Must use plug that complies with IEC-309 at 75 Amps at 220VAC
[ ] 24kVA Must use plug that complies with IEC-309 at125 Amps at 220VAC
Dimensions:
Blackbody Enclosure:
Controller:
34.5” (87.6 cm) H x 22” (55.9 cm) W x 38.5” (97.8 cm) D
19” Rack mount, 7” (17.8 cm) H x 18” (46 cm) D.
Maximum Weight: 182 kgs (400 lbs)