Rhino Shelter HOUSE-14W X 42L X 15H - Manual (Page 8)

Assembly Instructions RV Style 14 x 42 x 15
V 2.2
Please Do NOT Return Assembly To Dealer or Store. For All Questions and assistance, contact MDM Products directly.
Customer Service 203-877-7070 or 800=447-7079
8
END DOOR STEP 2. - ATTACH END DOOR
Wrap the edges of the panel around the frame
arch, bringing the slits in the panel, to the inside of
the frame. End Panel / Doors have pre-cut slits that
allow Cross Rails to pass through, so material can
wrap around arch with rope pocket inside unit
Thread the Cross Rails through the slits and re-attach
to the frame arch using carriage bolts, with nuts and
washers facing inward as always. End Panel/Door
will also require removal of Wind Brace bolts, and
placement of Wind Brace through slits in End Panels.
Remember to reconnect Wind braces with carriage
bolts and tighten down, once End Panel is in place.
END DOOR STEP 3. TIGHTEN AND SECURE END
PANEL DOOR
Tie off one end of the rope coming out of the end
panel to a TURNBUCKLE (turnbuckle should be
loosened all the way), and attach the turnbuckle to
the hole in the Corner Foot of the End Arch. Grab
the other end of the rope and apply downward
pressure with your foot to tighten the fabric around
the arch and remove excess slack. Distribute
excess fabric along door rope pocket to keep door
centered on frame.
NOTE: Adjust the end panel door by turning the
turnbuckles or repeating step 3 till taut.
Repeat for other End Panel / Door
STEP 10 – MAIN COVER
The Main Cover should only be installed after the
frame is entirely secured to the ground and the
end doors are already in place.
MAIN COVER STEP 1.
To elongate the life of Main Cover, put a small
square of duct tape (field supplied) over each bolt
head on frame that comes in contact with cover.
The tape acts as a cushion to avoid rubbing damage
to the cover over years.