Rhino Shelter HOUSE-14W X 42L X 15H - Manual (Page 9)

Assembly Instructions RV Style 14 x 42 x 15
V 2.2
Please Do NOT Return Assembly To Dealer or Store. For All Questions and assistance, contact MDM Products directly.
Customer Service 203-877-7070 or 800=447-7079
9
Unpack the Main Cover #MUC-8000 from the
protective plastic packaging. The line of grommets
on the inside (white) of the cover on the tie down
Flap run parallel to the sides of the frame assembly
for positioning.
Pull Main Cover over frame with rope threaded
through one of the grommets on the end flap. Be
careful not to snag or rip the cover on any exposed
bolts or rough ends.
MAIN COVER STEP 2. TIGHTEN COVER DOWN
The Main Cover will tighten down at the end of the
frame in the same manner as the End Panel/Doors.
Take the remaining turnbuckles, fully loosened and
place into the holes in the Corner leg Feet, FROM
THE OUTSIDE. Tie off one end of the rope to the
turnbuckle, take up extra slack, tie off that end
temporarily to hold it’s position. Go to opposite end
of unit, do the same. Adjust gathers in material
evenly around arch. Keep repeating until Main Cover
is taut and gathers are evenly distributed. It is
important to work evenly from end to end, this will
keep the cover from pulling to one side more than the
other. Cover can be tightened further by adjusting
the turnbuckles.
Turnbuckle on Main Cover goes on the Outside of
the End Panel/Zipper Door
Inside Corner view showing Main Cover and End
Panel Door properly laced and secured with turn
buckles.
Pay close attention to how tight the cover is put onto
the frame. It should be tight enough so it does not
flap around in the wind, but not so tight that it tears
the material cover. The fabric backed PE fabric of
Rhino Shelter units does not stretch. If you pull it so
tight that the fabric is stretched, a small amount of
additional stress from wind or contact can cause
premature tears and failure. Only tighten cover