Seed Hawk GRANULAR AND LIQUID TANKS 2009 User Manual
Page 47
Seed Hawk Manual
Granular and Liquid Tanks
Page 45
5. Install New System- Plug
your sensors in as the monitor
asks for them. For sensors that
are unavailable, Press SELECT
to SKIP this Sensor. The first
sensor the monitor will look for
is a Ground Speed sensor. This
is an implement-mounted
sensor monitoring a shaft. Plug
it in now. A Ground Speed
Sensor must be installed for the
monitor to function correctly.
Once the Ground Speed Sensor has been accepted, the monitor will request the
next sensor. The order the monitor will request the sensors, is shown below. If
the monitor requests for a sensor that is not in your system, Press Select to Skip
this Sensor.
•
Speed
• Fan 1
• Fan 2
• Meter 1
• Meter 2
• Meter 3
• Bin 1
• Bin 2
• Bin 3
Note: If during the Learn Mode you receive a Wrong Sensor Type
message, the sensor connected to the harness is not the correct
sensor. For example: This message would appear if monitor requests
the Speed Sensor but a Hopper Sensor is connected to the harness
in error. However, use caution during the learn procedure, functions
such as Fan or Meters use the same sensor type. Therefore they
could be learned incorrectly.