Spectra Precision ProFlex 800 Web Server - Manual (Page 24)

20
Automatic: The radio will be switched on or off
automatically when the rover is respectively turned on
or off.
Manual: The radio will be powered up only by going
through the
Rover Setup page, setting the internal radio
to “Power On” and clicking on the Configure button (or
using the $PASHS,RDP,ON command).
– Channel: Select the channel on which you know that
the base is transmitting its RTK corrections.
– Protocol: Select the data protocol used in the data
transmission:
“Transparent”, “Trimtalk450S”, “SATEL”,
“TrimMark II/IIe”, “TT450S”, “TRIMMARK3”,
“Transparent FST” or “
U-Link”.
This choice should be the same as the one made at the
base.
– Airlink Speed: Choose the data transmission speed
(should be the same as the one used at the base).
– ( Type is just a read-only field recalling the type of radio
used.)
– Sensitivity: Set the radio sensitivity level (“High”,
“Medium” or “Low”)
– Scrambler: On or Off
– FEC: On or Off
– Current Power: 0.1, 0.5 or 1.0 W.
• Ignore the External Radio pane (Type should be set to
“No
ne”).
• Click on the Configure button to let the Web Server load the
parameters to the radio via the receiver. You just have now
to define the output messages (see Defining Output
Messages on page 30).
Direct IP Via
Modem
Modem
RTK Corrections
ProFlex 800
Base
(Mobile Wireless
Communication)
Internet
IP address
or server name
(Client)