Ntrip client via ethernet – Spectra Precision ProFlex 800 Web Server User Manual

Page 30

Advertising

Select the desired source by simply clicking on the
corresponding row. The resulting mount point then
appears in the

Mount Point field located above the Load

Source Table button.

–

Send NMEA: Check this button when the rover operates
in a VRS network so that it can return its position to the
network through an NMEA message. Keep it cleared in
all other cases. (This option is automatically enabled
when you select a mount point for which the NMEA
message is requested.)

• At the bottom of the page, in the

Differential Port pane,

select the

Automatic option to let the receiver detect the

incoming differential stream automatically.

NOTE:

Automatic is the recommended choice for the

Differential Port setting because in this case, you don’t
need to define the ports receiving the two possible
differential streams.

• Click on the

Configure button to let the Web Server load all

your new parameters to the receiver. You just have now to
define the output messages (see Defining Output
Messages on page 30).

NTRIP Client Via

Ethernet

• First, click on the

Connections> Ethernet submenu.

• Set the following Ethernet parameters to allow the receiver

to access the network through its Ethernet port:

–

DHCP: Enabling this option means the local network to
which the receiver is connected will automatically
allocate a dynamic IP address to the receiver. If this
option is disabled, you need to define the receiver’s
static

IP address, and give information about the local

network (

Subnetwork Mask and Gateway). You may need

to be assisted by a network expert -or IT Manager- to
define these parameters (as well as the three
parameters below).

RTK Corrections

Ethernet

ProFlex 800

NTRIP caster

IP address
or server name

(Client)

Internet

Advertising