9100 i, Important – Triton 9100 Installation Manual User Manual

Page 22

Advertising
background image

22

M

ODEL

9100 I

NSTALLATION

M

ANUAL

9.

Route the serial communications cable and power cable through the Ty-wrap loop located on figure
below. Plug the data cable into jack J11. Plug the DC power connector into jack J12 Pull Ty wrap to
secure cables to dispenser.

Cable tie wrap near data / power connections.

Important

After the dispenser and cables have been installed, rotate the turntable a few
times to ensure the cables do not bind or are placing stress on the dispenser
connectors.

10. Next, plug the ground wire to the dispenser as shown. Use a Ty-wrap to secure.

Ground wire connection

Ty-wrap

Advertising
See also other documents in the category Triton Equipment: