Triton 9100 Installation Manual User Manual

Page 25

Advertising
background image

25

I

NSTALLATION

P

ROCEDURES

5.

Loosen the wing nuts on the dispenser tray. Grasp the dispenser and place on the tray. The mechanism
should slide under two tabs in the rear and the front edge slots should align with the two bolts
provided with wing nuts. Once the mechanism is fully engaged on to the tray, tighten the wing nuts by
hand.

Align slots with

wing nuts.

*Note*

If you have an older dispenser (see
*NOTE* previous pages), you
MUST remove the spacer bar!

6.

Check to ensure the data and power cables are not resting on any moving parts of the dispenser (belts,
timing wheel).

Advertising
See also other documents in the category Triton Equipment: