Triton 9100 Installation Manual - Manual (Page 27)

27
I
NSTALLATION
P
ROCEDURES
7. Plug the power and data cables into the mating connectors on the back of the dispenser. Make sure the
white strain clip on the power cable is pointing down. Make sure the thumbscrews on the data cable
are securely tightened.
8. Refer to Figure at right. Slide the mechanism under
the rear screws on the tray and align the front with the
screw holes at the left and right corners of the
mechanism chassis. Secure using two (2) screws
provided in the accessory box.
Power cable
Data cable
**CAUTION**
Do not remove the yellow connector (w/
jumper wire attached) located next to
the data cable receptacle from the main
board assembly. If it is removed, the
dispensing mechanism will not operate.
NOTE
On very first TEST DISPENSE, the dispenser performs a Learn Note Thickness routine. This
causes the dispensing mechanism to dispense six (6) notes from the Note Cassette into the
reject area of the cassette. This operation will calibrate the double detect on the dispensing
mechanism and test the mechanisms ability to pick currency from the cassette. After com-
pleting the Test Dispense operation, a Return Code of ‘20 20 26’ should be indicated on the
display. This indicates that six notes were successfully moved from the Note Cassette to
the Reject compartment. An additional Test Dispense should dispense one note from the
cassette to the Reject compartment and display a Return Code of ‘20 20 21’. This is the
normal return code for a successful relearn.