Pc6152 – Acnodes PC6152 User Manual
Page 60
14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
PC6152
15” Core 2 Duo touch anel PC
0 through 4 provide successively increased performance. In Auto mode, the system automatically
determines the best mode for each device.
5. SATA Mode:
Set the Serial ATA configuration. When set in Advanced Host Controller Interface (AHCI) or RAID
mode, the SATA controller is set to Native mode. Configuration options: [IDE] [RAID] [AHCI].
6. Primary Master/Slave UDMA Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive
supports it and the operating environment includes a DMA driver (Windows 95 OSR2 or a third-
party IDE bus master driver). If you hard drive and your system software both support Ultra DMA/
33, select Auto to enable BIOS support.
7. On-Chip Serial ATA:
[Disabled]: Disabled SATA Controller.
[Auto]: Auto arrange by BIOS.
[Combined Mode]: PATA and SATA are combined. Max.of 2 IDE
drives in each channel.
[Enhanced Mode]: Enable both SATA and PATA. Max.of 6 IDE drives are supported.
[SATA Only]: SATA is operating in legacy mode.
8. PATA IDE Mode
To select PATA IDE Mode sequence
9. SATA Port
According PATA IDE Mode to determine SATA sequence
ONBOARD DEVICE:
The options for these items are found in its sub menu. By pressing the <ENTER> key, you are prompt
to enter the sub menu of the detailed options as shown below: