USGlobalsat TR-206 User Guide - Manual (Page 59)

TR-206 page 59
13 Simple Command
You could send simple commands to the TR-206 through a
mobile phone
’s SMS. In order to protect the privacy, the simple
command should be followed by the password of the
“Device
Utility.
” (Please refer to page 48 and page 52.)
The simple commands must be in capital letters.
The simple commands can be optionally added with an equal
mark and concerning parameters. If you do not add the
parameters, the TR-206 will take the present configuration as
the main setting.
The simple commands are
“ping TR-206”, “TR-206 periodic
report
”, “TR-206 motion report”, and “Link to server.” For ping
command, you could set the tolerance time of GPS fix. For
periodic report, you could set the report interval. For motion
report, you could set the static and moving report interval. There
are two simple commands for theTR-206 to switch to motion
report. The first one is
“MM”, which is used for setting the moving
report interval. The other one is
“MS”, which is used for the
setting static report interval. The unit of the simple command
concerning parameters is in seconds.
The table for simple commands is shown in the next page.
You could send several simple commands in one SMS. The
simple command is separated by a
“comma” (,).