Video Mount Products LCD-MID-CB User Manual
Page 3
Step 1
Before starting, lay out all parts to your mount and match them to the
parts list provided. Verify that you have all your parts before attempt-
ing to assemble the mount.
Step 2
Mark the ceiling or desired mounting surface in preparation of instal-
lation of ceiling plate . If mounting to wooden ceiling joists, pre drill
pilot holes using a 7/32” drill bit. Attach the ceiling plate to the
wooden ceiling joist using the 5/16” by 2.5” long lag screw and
washer . WARNING: Please verify that your mounting surface will
support the combined weight of your mount, mounting hardware, and
fl at panel. Also verify that the mounting surface is safe to drill through.
Please note only mounting hardware for mounting to wooden ceiling
joists will be provided with the unit. If mounting to a surface other than
wooden ceiling joists then other hardware will be required. If in doubt
or uncertain about any of the above, please contact a professional
installer.
Step 3
Screw the outer mast into the ceiling plate as tight as possible.
Then proceed to take the ¼” – 20 brake screw tighten it down
into the pipe couple on the ceiling plate using the M3 Allen key
. Note: It is important to tighten down the brake screw as far
a possible to prevent the outer mast from rotating out of the pipe
couple on the ceiling plate .
Step 4
Insert the inner mast into the outer mast and pin the inner mast
into place at the desired height using the 5/16” by 2.5” long hex head
screw and nylon nut .
Step 5
Screw the pipe couple onto the inner mast as tight as possible.
Then tighten the ¼” – 20 brake screw into the pipe couple using the
M3 Allen Key . Note: It is important to tighten down the brake screw
as far a possible to prevent the pipe couple from rotating off of
the inner mast .
Step 6
Attach the base plate to the pipe couple using
the large washers , PVC washers and M16 nylon
nut . Once the nylon nut is tight, slide the cot-
ter pin through the small hole near the bottom of
the screw coming out of the pipe couple . Note: Be
sure to tighten down the nylon nut as far as possible
to prevent sag or list in the mount.
Step 2 : Mounting the ceiling plate
Step 3: Attaching the outer mast
Step 4 : Attaching the inner mast
Step 5 : Attaching the pipe couple
Step 6 : Attaching the base plate
11
10
1
3
3
2
2
1
2
20
20
19
19
3
4
4
1
1
40
41
19
1
19
7
38
5
4
6
6
39
4
6