Video Mount Products LCD-MID-CB - Manual (Page 4)

Step 7
Attach the tilt plate to the base plate by fi rst inserting plastic
washers in between the base plate and tilt plate on each side.
Then insert the 5/16” by ¾” long square neck screws into the
base plate so the screws are pointed outwards. On the bottom
screws on each side secure the screws with the 19 mm outer diam-
eter washers and nylon nuts . On the upper screws place
the 25 mm outer diameter washers and use the gear nuts ,
lever handle and lever screw to secure the tilt plate’s
)
position. Tilt the tilt plate as far up as it will go and lock the tilt
into place by tightening down the lever handle as far as it will
go on each side. Note: This is important to do to allow step 9 to be
accomplished safely and easily.
Step 8
Determine the correct screw size and if you need to use washers,
lock washers, or spacers. Note: Spacers are used for TVs with re-
cessed hole patterns. Secure the display to the screen mounting
brackets using the appropriate hardware through .
Note: The brackets have to be level with each other to work properly.
Step 9
Make sure the tilt plate is locked into place by tightening down
the lever handles as far as they will go. Lift the screen mount-
ing brackets with the attached fl at panel onto the tilt plate
. Then while another person is holding the fl at screen in place
tighten down the security screws as far as they will go with the
long Allen key to lock the screen mounting brackets into
place. Once the screen mounting brackets are secure then
you can adjust the tilt by loosening the lever handles and ad-
justing the tilt plate to the desired position and then retighten-
ing the lever handles once it is in position.
Please verify that all nuts and screws are securely tightened.
Step 7 : Attaching the tilt plate
Step 8A : Attaching the mounting
brackets to the screen
(spacers not needed)
15
22
17
12
7
7
14
13
42
16
18
21
8
Step 8B : Attaching the mounting
brackets to the screen (spacers used
due to recessed hole patterns)
Step 9 : Attaching the mounting
brackets to the tilt plate
WARNING: The installer of these products must verify that the mount sur-
face, ceiling or wall, will safely support the combined weight of all at-
tached equipment and hardware. Video Mount Products will not be held
liable for the improper use or installation of its products.
Enjoy Your Mount!
8
8
17
23 37 9
17
8
9
8
9
9
17
8
17