Video Mount Products PDS-LCB - Manual (Page 3)

Step 1
Before starting lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount.
Step 2
Slide either extension brackets A or B ( or depending on
which works better for your TV) onto the mounting plate and
match up the slots on the extension brackets to the holes on the
back of your TV.
Step 3
Determine the correct screw size and if you need to use wash-
ers, lock washers, or spacers. Note: Spacers are used for TVs with
recessed hole patterns. Secure the TV to the extension brackets
( or ) using the appropriate hardware ( through ).
Step 4
Center the mounting plate on the TV and use the 5/16” screws
and washers to secure the extension brackets ( or )
in place. Set this aside for now.
Step 5
Mark the ceiling or desired mounting surface in preparation of instal-
lation of ceiling plate . If mounting to wooden ceiling joists, pre-
drill pilot holes using a 7/32” drill bit. Attach the ceiling plate
to the wooden ceiling joist using the 5/16” by 2.5” long lag screw
and washer . WARNING: Please verify that your mounting
surface will support the combined weight of your mount, mounting
hardware, and fl at panel. Also verify that the mounting surface is
safe to drill through. Please note only mounting hardware for mount-
ing to wooden ceiling joists will be provided with the unit. If mounting
to a surface other than wooden ceiling joists then other hardware will
be required. If in doubt or uncertain about any of the above, please
contact a professional installer.
Step 2 : Assembling the
mounting rails
Step 3A: Attaching the
mounting rails to the fl at pan-
el (holes are not recessed)
Step 4 : Securing the mounting
rails to the mounting bracket
Step 5 : Attaching the ceiling
plate to the ceiling
18 42
17
42
Step 3B: Attaching the
mounting rails to the fl at
panel (holes are recessed)
18 42 27
17
20 19 18 42
1
1
46 47