Video Mount Products PDS-LCB - Manual (Page 5)

Step 9
Attach the swivel bracket to the pipe couple using the large
metal washers , PVC washers and M16 nylon nut . Once
the nylon nut is tight, slide the cotter pin through the small
hole near the bottom of the screw coming out of the pipe couple
. Note: Be sure to tighten down the nylon nut as far as pos-
sible to prevent sag or list in the mount.
Step 10
Attach the adjusting bracket to the swivel bracket using the
M10 screws , washers and nylon nuts . Insert the adjust-
able screw into the back of the swivel bracket . This screw
will control your tilt.
Step 11
Lift the mounting plate with the TV onto the adjusting bracket
inserting the metal tabs on the adjusting bracket through
the slots on the mounting plate . WARNING: This step requires
at least two people to prevent possible injury. Use the M5 screws
, washers , and long Allen key to secure the mounting
plate to the adjusting plate .
Verify all screws and nuts are securely fastened.
Step 9 : Attaching the swivel
bracket to the pipe couple
Step 10 : Attaching the adjusting
bracket to the swivel bracket
Step 11 : Attaching the mounting
bracket to the adjusting bracket
WARNING: The installer of these products must verify that the
mount surface, ceiling or wall, will safely support the combined
weight of all attached equipment and hardware. Video Mount
Products will not be held liable for the improper use or installation
of its products.
Enjoy Your Mount!
44
45
5 4
6 7
7
4 7
25 5
24
22
21
26 5
17
25
25
17
16 43
23
17 25