WEN 3912 10 inch band saw - Manual (Page 10)

Assembly and adjustments
Unpacking
Carefully unpack the band saw and all its parts, and compare against the list below. Do not
discard the carton or any packaging until the band saw is completely assembled.
WARNING: If any part is missing or damaged, do not plug in the band saw until the
missing or damaged part is replaced.
A Band Saw (1) H Short Support Plate (2) P Screw M6x12 (4)
B Table Insert (1) J Long Support Plate (2) Q Bolt (16)
C Table (1) K Wrench (1) R Flat Washer 8 (20)
D Miter Gauge (1) L Combination Wrench (1) S Nut 8 (16)
E Fence (1) M Rail Lock Knob (4) T Nut 6 (1)
F Rail Guide (1) N Rubber Foot (4) U Lock Washer (4)
G Stand Leg (4) O Screw M6x32 (1)
Tools Required for Assembly & Adjustments
The tools listed below are not included but are required for assembly.
2
14mm Open End Wrench
1 Cross Point Screw Driver
1 Combination Square
10