WEN 3914 14 inch band saw - Manual (Page 8)

Guidelines for Using Extension Cords
Make sure your extension cord is in good condition. When using an extension cord, be sure to
use one heavy enough to carry the current your product will draw. An undersized cord will cause
a drop in line voltage resulting in loss of power and overheating. The table below shows the
correct size to be used according to cord length and nameplate ampere rating. When in doubt, use
a smaller-numbered gauge (the smaller the gauge number, the heavier the cord).
Minimum Gauge for Extension Cords (AWG)
(when using 120 V only)
Total Length of Cord in feet
25 Feet 50 Feet 100 Feet 150 Feet
18 Gauge 16 Gauge 14 Gauge 12 Gauge
Be sure your extension cord is properly wired and in good condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it.
Protect your extension cords from sharp objects, excessive heat and damp or wet areas.
Use a separate electrical circuit for your tools. This circuit must not be less than a #12 wire and
should be protected with a 15 A time-delayed fuse. Before connecting the motor to the power
line, make sure the switch is in the OFF position and the electric current is rated the same as the
current stamped on the motor nameplate. Running at a lower voltage will damage the motor.
WARNING: This tool must be grounded while in use to protect the operator from
electrical shock.
8