WEN 70711 10 inch Sliding Compound Miter Saw Manual - Manual (Page 23)

23
Troubleshooting
PROBLEM POSSIBLE CAUSES LIKELY SOLUTIONS
Blade binds, slowing
or stopping saw.
1 . Material is misaligned
on the saw or ends
are not supported .
2 . Material is wet, con-
taminated or inappro-
priate blade is being
used .
1 . Material must be flat on table, flush against
the fence and supported on both ends .
2 . Check condition of material and check com-
patibility of blade to material .
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.