WEN 4210 10 Variable Speed Drill Press - Manual (Page 11)

4212 WENPRODUCTS.COM 11
Assembly and adjustments (continued)
Note: Make sure there is enough clearance to allow the table to rotate around the column. The collar must
sit loosely over rack and not angled on the column. To avoid column or collar damage, only tighten the set
screw enough to keep collar in place (Fig. 3).
7. Insert the table support crank handle (9) into the worm gear
shaft on the side of the table support (8). Make sure the set
screw (10) is aligned on the flat of the shaft and as close to the
table support as possible. Tighten the set screw (Fig. 7).
8. Position the table in the same direction as the base, and tighten
the column lock handle (11).
Drill press head to column
(Fig. 6)
1. Lift the drill press head assembly (1) carefully and place the
mounting hole of the drill press head onto the top of the
column (2). Make sure the head is seated properly on the
column.
2. Align the direction of the drill press head to the direction of
the base and the table.
3. Tighten the two set screws (3) using an Allen wrench.
Feed handles (Fig. 7)
1. Insert the three feed handles (1) into the threaded openings on
the feed hub (2).
2. Manually tighten handles into openings.
Note: When using the drill press, one or two of the feed
handles may be removed if an unusually-shaped
workpiece interferes with handle rotation.
Fig. 5
11 9
10
8
3
Fig. 6 2
1
Fig. 7
1
2