WEN 2312 Variable Speed Multi-Tool Kit - Manual (Page 9)

9
ASSEMBLY
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts
are missing or broken, please call our customer service at 1-800-232-1195.
Assembly Instructions
Warning: To Prevent Serious Injury From Accidental Operation:
Turn the power switch of the tool to its “OFF” position and unplug the tool
from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to
the Exploded View and Parts List near the end of this manual.
Prior to attaching or removing any one of
the attachments, turn off the unit and
unplug the tool from its electrical source.
Place attachment over Spindle shoulder
and facing forward. Insert the Cap Screw
into the Outside Flange. Tighten the cap
screw using the provided Key Wrench.
Torque firmly (Approximately 100 in-lbs).
(Figure 1)
Note: Some units may have small holes in the attachments and/or pins on the spindle
shoulder. These are not used or required for this model.