AW Gear Meters EMO-3000 - Manual (Page 25)

EMO‐3000
Operation and Programming Manual
24
You can view and reprogram all variables via the F2 function shown above (General A). The other F keys
shown above provide shortcuts to specific sections of the variable table. Page 46 shows a full list of
variables.
The choices are explained on these pages.
F1 = MAIN MENU This page
F2 = GENERAL A Page 24
F3 = P I D VARIABLES Page 25
F4 = GENERAL B Page 25
F5 = ANALOG VARIABLES Page 26
F6 = LIMIT VARIABLES Page 26
1 = LIMIT RULES Page 27
2 = RATIOS Page 28
3 = LINEARIZER Page 29
4 = SPECIAL REPEAT Page 29
F1 = MAIN MENU (ESC)
This key returns you to the Main Menu.
F2 = GENERAL A
The General A screen (below) shows the first six variables from a complete list of 50 variables. The full
list including default values appears on page 34.
*** GENERAL VARIABLES *** CH = XXX
‐‐‐‐> KFR FACTOR = XXXX.X
RATE ENG.UNIT = ??
KFT ‐ FACTOR = XXXXX.
TOTAL ENG.UNIT = ??
SAMPLE AMOUNT = XXXXX.
CUTOFF FREQ. = XXXX.X
F1 = ESC F2 = PGUP F3 = PGDN F4 = PRGM
Notice