Catskill Craftsmen 51524 - Manual (Page 11)

STEP 15
Install Shelves/Disks
A. Upright unit and insert drawer. If
drawer front hits the top front brace,
tap brace down. Take bottom shelf
(no edge banding) and place it on
the set of back pins as shown. Close
doors and shelf will drop into place.
DO NOT FORCE!
B. Tap two 1” pins into each side
panel to hold middle shelf, making
sure the pins on both sides are in the
same relative position. To remove a
pin, use pliers or a claw hammer.
C. Place middle shelf, edge banding
out, on pins.
D. Once drawer fit is correct,
re-tighten screws and insert wooden
disks into sides.
Edge
Banding
4 used in
this step
1” LONG 3/16” DIA. STEEL PIN
STEP 16
Assemble Backsplash
Attach the backsplash to the back
edge of the table top with 1 1/4” #8
screws in three places as shown.
3 used
in this step
1 1/4” #8 PHILLIPS FLAT HEAD SCREW