Catskill Craftsmen 51524 - Manual (Page 7)

STEP 6
A. Lay back panel flat on a smooth surface
with holes up.
B. Attach side panels with 1 3/4” bolts and hex nuts.
After inserting bolt(s) through the holes in the side
panels and through the holes in the long edges of the
back panel, place a hex nut on the tip of your finger,
align nut with bolt and tighten.
C. Look ahead to step 8 which shows side panels
attached to back panel.
NOTE: Back panel is flush with bottom of
side panels.
1 3/4” Phillips Flat Head Bolt (8)
4 Used
in this step
10-24 Hex Nut (8)
4 Used
in this step
STEP 7
A. Invert table top on a
smooth flat surface and
make a large X mark over
each of the 4 inside pilot
holes in the bottom. Make
marks about 1 1/2” long.
These marks will help you
align the cabinet with the
pilot holes.
Outer holes will not be used.
FRONT
BACK
use the inside set of holes
Side Panel Leg
Inside Brace
Countersunk Hole in Leg
( disk goes in this hole to
hide bolt head! )
Nut Access Hole
Hex Nut