Catskill Craftsmen 51524 - Manual (Page 8)

4 Used in this step
1” Long 3/16” DIA. Steel Pin
PIN
PIN
5/8” Phillips Head #7 Screw
4 Used in this step
ILLUSTRATION 8
STEP 8
Attach Side/Back Assembly To
Table Top/Tap Bottom Shelf Pins
Into Side Panels
A. Turn the side/back assembly upside
down (invert) on top of the inverted table
top.
B. Using the X marks as a guide, insert
the tips of the screws into the pilot holes
through “L” bracket slots in the unit top
and finger tighten. When all 4 screws are
properly aligned, tighten down.
D. Tap two 1” pins into EACH side
panel. These pins will hold the bottom
shelf. See illustration 8.
STEP 9
Attach Top Front Brace
A. Take the top front brace (with
magnet block), insert the pins in
the brace ends into the slits on the
inside of the front legs and slide
down until the brace is aligned with
holes in leg as illustrated. Secure
with bolts/nuts.
1 1/4” #8 Bolts
Insert Brace Pins Here
Glide Suport
Assembly
ILLUSTRATION 9
2 used
in this step
Hex Nut
2 used in
this step
1 3/4” Phillips Flat Head Bolt