COSA Xentaur COSA 707 - Manual (Page 32)

COSA Instruments USER MANUAL COSA 707
www.cosaxentaur.com 32
12.3 Measured Value Display
After the core flow search you will see the measurement values on the display.
Measurement values can be organized on three pages, each page displaying 6 measurement val-
ues.
The order of the display is operator settable. (see chap. 9.4.4).
There are direct measured values available such as Oxygen and Temperature as well as calcu-
lated values such as dew point, efficiency and CO
2
. You will also find the same measurement
value in different calculated values such as CO in ppm or CO in mg/kWh.
Values that cannot be displayed are indicated with dashes. Possible reasons for value not being
displayed are:
• Electro chemical sensor was detected as defective during zeroing.
•
External temperature sensors are not connected.
The measurement value T-Gas is usually read at the connector “T-Gas/AUX” (depending on con-
figuration) or if not available from the connector “T1”. (see chapter 6)
There are three measurement windows available, with the arrow keys left and right moving be-
tween them.
Zoom function, each with two values, is activated by moving the arrow keys up and down. Moving
arrow keys left and right pages between the two zoom windows.