COSA Xentaur Xentaur LPDT - Manual (Page 38)

Appendices
page 31
Appendix A: Operating State User Interface flowchart
TEMP ˚F
XENTAUR LPDT
SET
XENTAUR LPDT
SET
XENTAUR LPDT
XENTAUR LPDT
Press together to
RESET the Instrument.
Then quickly press and hold
MODE to go to Set-Up State.
Sensor
Reading Too Low
OK
Viewing
Dewpoint
Viewing
Sensor
Temperature
Calibration
Menu
Viewing
Serial
Number
Cancel Calibr
ation (calibr
ation v
alues are not changed)
1 minute
1sec.
fe w seconds
2 sec.
1 sec.
Ne
w Calibr
ation
V
alues Stored
select
units
select
units
SET
XENTAUR LPDT
numbers calculating
calibration
SET
XENTAUR LPDT
SEN/2LO
SET
XENTAUR LPDT
AC/_AC
SET
XENTAUR LPDT
CNF/AC?
XENTAUR LPDT
CAN
Confirm
SpanCheck™
LEGEND: 1. Arrows leading out from below a button depict the flow as a result of
pressing the button.
2. Arrows leading out of other locations depict flow as a result of
completing a function or a time-out.
3. A slash '
/ ' in the display area, is used to depict two alternately
shown (flashing back and forth) messages.
Power ON initialization
and sign on message
30 seconds anywhere
other than calibration
without a key press
DEWPOINT ˚C
XENTAUR LPDT
PSI
a flashing
PSI legend
means pressure
correction is
being applied,
see appendix F