DeFelsko PosiTector SPG v.1.1 Full Manual - Manual (Page 30)

27
The battery indicator displays a full bar with fresh alkaline or
fully charged batteries installed. As the batteries weaken, the bar will
be reduced. When the battery symbol is low the Gage can still
be used, but the batteries should be changed or recharged at the
earliest opportunity. The Gage will turn off automatically when batteries
are very low, preceded by a Low Battery Warning on the display.
To retain all user settings and stored memory readings, only
replace the batteries after the Gage has powered-down.
Battery performance decreases at low temperatures.
Power Supply / Battery Indicator Power Supply / Battery Indicator
Power Source: 3 AAA alkaline, Lithium or optional Nickel-metal
hydride (NiMH) rechargeable batteries. For best battery indicator
results, ensure the appropriate Battery Type is selected in the
Setup > Battery Type menu (pg. 10).
!
Determines if a software update is available for your Gage. If an update
is available, a prompt will appear allowing the user to choose to
perform the update at this time or not.
To perform an update the Gage must be connected to an internet
connected PC with PosiSoft Desktop Manager (pg. 18), or WiFi
network (pg. 24).
Updates
Ensure that stored measurements are backed up to a PC or
PosiSoft.net. The Gage may perform a Hard Reset (pg. 9) after
completion of the update and ALL readings in memory would be
erased.
NOTE:
2 / 3
DO NOT unplug the Gage during the update operation.
Currently installing
update 2 of 3 total
Progress bar
Updates - Sample Screen
!
Setup: Allows user to setup a WiFi connection
IP Settings: enter the IP information as follows... •
IP Type (DHCP or Static), IP Address, Gateway, Netmask, DNS1,
DNS2.
Server Enable: enables a connection between the network and
•
the Gage.
Gage Name: enter a name for the Gage (up to 14 Characters).
•
WiFi Reset: erases all WiFi settings. •